+49 2181 / 75 6 75 - 0

PSU R2G-5500V4V (80+) 500W Red. 2U RoHS

item no.: A 1780

Not in stock
-- €
send inquiry for this product
  • Description
  • Specs
  • Downloads
  • Related Products

  • 500W / High efficiency
  • 2U redundant
  • Best solution for: Server, Workstation, Storage System
  • SPECIFICATIONS:
    VOLTAGE: 90 ~ 264 VAC FULL RANGE
    DIMENSIONS: 276.00x101.00x82.00 (mm)
    10.87x3.98x3.23 (inch)
    FREQUENCY: 47 ~ 63 Hz.
    INPUT CURRENT: A/4A (115 / 230 VAC) POWER MODULE
    INRUSH CURRENT: 60A/80A MAX. FOR 115/230 VAC POWER MODULE

    +5V AND +3.3V TOTAL OUTPUT MAX : 170W

    TOTAL OUTPUT MAX: 500W

    Output Voltage Output
    Current
    Min
    Output
    Current
    Max
    Output
    Current
    Peak
    Regulation
    Load
    Regulation
    Line
    Output Ripple &
    Noise Max [P-P]

     +5V

     0.5

     25

     

     ± 5%

     ± 1%

     50mV

     +12V

     2.0

     40

     

     ± 5%

     ± 1%

     120mV

     -12V

     0.2

     0.8

     

     ± 10%

     ± 1%

     150mV

     +3.3V

     0.5

     25

     

     ± 5%

     ± 1%

     50mV

     +5VSB

     0.1

     3.5

     

     ± 5%

     ± 1%

     50mV


    FEATURES:

    - TEMPERATURE RANGE: OPERATING 0°C~40°C, OPERATING TEMPERATURE: -20°C~80°C

    - HOLD UP TIME: 16mS MINIMUM AT FULL LOAD & NOMINAL INPUT VOLTAGE

    - DIELECTRIC WITHSTAND: INPUT/OUTPUT 1500 VAC FOR 60 SECOND INPUT TO FRAME GROUND 1500 VAC FOR 60 SECOND

    - EFFICIENCY: TYPICAL > 80% AT 115VAC, 20%~100% MAX LOAD

    - POWER GOOD SIGNAL: ON DELAY 100mS TO 500mS

    - OVER POWER PROTECTION: 110% ~ 180%

    - OVER VOLTAGE PROTECTION: +5V->5.9V~>6.7V; +12V->13.0V~15.0V; +3.3V->3.9V~4.3V SHORT

    - SHORT CIRCUIT PROTECTION: +5V, +3.3V, +12V, -12V, AUTO-RECOVERED: +5VSB

    - OVER CURRENT PROTECTION: +3.3V: 27.5~37.5A, +5V: 27.5~37.5A, +12V: 44~76.8A

    - EMI NOISE FILTER: FCC CLASS B, CISPR22 CLASS B

    - SAFETY: TO MEET UL, CUL, TUV, CCC

    - REMOTE ON/OFF CONTROL

    THE POWER SUPPLY SHALL ACCEPT A LOGIC OPEN COLLECTOR LEVEL WHICH WILL DISABLE/ENABLE ALL THE OUTPUT VOLTAGE (EXCLUDE +5V STANDBY). AS LOGIC LEVEL IS LOW,OUTPUTS VOLTAGE WERE ENABLE, AS LOGIC LEVEL IS HIGH:OUTPUTS VOLTAGE WERE DISABLE.

    - N+1 REDUNDANCY FUNCTION

    - HOT-SWAPPABLE FUNCTION

    - CURRENT/BALANCE LOAD SHARING DESIGN

    - +3.3V REMOTE SENSING

    - ISOLATION: BUILT-IN IN POWER MODULE

    - POWER FACTOR CORRENTION: ACTIVE (MEET IEC-1000-3-2)

    - COOLING: 40mm DC FANS (one module)

    - DIMENSION: 276(D)×101(W)×82(H) mm


    REMARKS:

    *THE POWER-SUPPLY IS FOR CHASSIS-ASSEMBLY ONLY AND IS NOT ALLOWED TO BE OPERATED AS STAND-ALONE COMPONENT. FINAL ASSEMBLY HAS TO COMPLY WITH CORRESPONDING EMC- AND SAFETY-REGULATIONS.